Kool Stop Eagle 2 Threaded White

Key Features:

  • Hardened and plated reinforced steel backbone
  • Angled tip to divert mud and rain away from the rim
  • Water groves
  • Pad-Lock washer system
  • Power Stop design
  • Weight: ca. 56 g/pair
  • Overall length: 64 mm
  • Pad contact width: 10 mm
  • Made in the USA

The Eagle 2 is a revolutionary pad that first utilized the hardened reinforced steel internal backbone. This larger pad has been used in all areas of cycling and is a good choice when frame, wheel and fork design allow. The extended pad length and off centre post design provides even wear for longer life.  A water groove is located below the mounting post for optimal water dispersion.  An angled plow tip is featured for rain and mud removal.  Supplied with the Power-Stop system which provides correct toe in during installation and allows alignment to any rim angle

The special White compound is for use in all conditions

Installation Instructions:

  1. Clean the rim surface before installing new pads
  2. Place the new Kool Stop pads into the brake caliper arms and finger tighten the nuts
  3. Squeeze brake lever to allow correct pad to rim alignment; tighten the nuts.  Do not over tighten
  4. Break In Pads.  Full stopping power may not develop until after several braking applications have conditioned the rim surface.  Proper "toe in" alignment prevents brake chatter
  5. Check the pad and rim alignment after the pads are broken in and after every ride
  6. Important: Do not ride the bike until the brakes are checked and functioning properly.  Designed for bicycle use only.  All Kool Stop Pads meet or exceed C.P.S.C and D.I.N bicycle standards

Supplied as a pair


MSRP: £10.50

Available

Quantity
Amba Distribution Limited
Powered by B2B Wave